filename: tfs 80g.doc version 1.3 14.11.2005 vi telefilter filter specification tfs 80g 1/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. measurement condition ambient temperature: 23 c input power level: 0 dbm terminating impedance: * input: 700 ? || -1,3 pf output: 700 ? || -1,3 pf source impedance: 100 ? load impedance: 100 ? characteristics remark: the reference level for the relative attenuation a rel of the tfs 80g is the mini mum of the pass band attenuation a min . the minimum of the pass band attenuation a min is defined as the insertion loss a e . the centre frequency f c is the arithmetic mean value of the upper and lower frequencies at the 3 db filter attenuation level relative to the insertion loss a e . the nominal frequency f n is fixed at 80,0 mhz without any tole rance. the given va lues for both the relative attenuation a rel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency f c is shifted due to the temperature coefficient of frequency tc f in the operating temperature range and due to a production tolerance for the centre frequency f c . d a t a typ. value tolerance / limit insertion loss a e 2,6 db max. 4,0 db (reference level) nominal frequency f n - 80,0 mhz centre frequency f c 80,0 mhz - passband pb - f n 5,0 khz pass band ripple (p-p) 0,2 db max. 1,5 db relative attenuation a rel f n ... f n 5 khz 0,2 db max. 1,5 db f n ... f n 10 khz 0,5 db max. 3 db f n - 120 khz ... f n - 60 khz 33 db min. 25 db f n + 60 khz ... f n + 120 khz 37 db min. 25 db input power level - max. 10 dbm operating temperature range otr - 0 c ... + 50 c storage temperature range - -40 c ... + 85 c frequency inversion temperature 30 c - temperature coefficient of frequency tc f ** -0,036 ppm/k 2 - *) the terminating impedances depend on paras itics and q-values of matching element s and the board used, and are to be understo od as reference values only. should there be additional ques tions do not hesitate to ask for an applic ation note or contac t our design team. **) ? f c (hz) = tc f (ppm/k 2 ) x (t - t o ) 2 x f to (mhz). generated: checked / approved:
filename: tfs 80g.doc version 1.3 14.11.2005 vi telefilter filter specification tfs 80g 2/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. filter characteristic 79.6 79.7 79.8 79.9 80 80.1 80.2 80.3 80.4 80.5 -100 -90 -80 -70 -60 -50 -40 -30 -20 -10 0 frequency in mhz magnitude in db 79.95 79.96 79.97 79.98 79.99 80 80.01 80.02 80.03 80.04 -15 -10 -5 0 frequency in mhz magnitude in db construction and pin connection (all dimensions in mm) 13,6max. 6,8max. 1 2,0max. 8 9 10 1,5 2,54 0,15 2,54 0,15 0,8 0,1 1 2 3 4 5 6 7 11 12 date code 100 ? test circuit 1, 2, 3, 4, 7, 8, 9, 10 tfs 80g t46 1 ground 2 ground 3 ground 4 ground 5 output 6 output 7 ground 8 ground 9 ground 10 ground 11 input 12 input date code: year + week t 2005 u 2006 v 2007 ... c1 l1 l3 saw l2 l4 c2 11 5 6 12
filename: tfs 80g.doc version 1.3 14.11.2005 vi telefilter filter specification tfs 80g 3/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. stability characteristics, reliability after the following tests the filter shall meet the whole specification: 1. shock: 500g, 1 ms, half sine wave, 3 shocks each plane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5 g respecti vely, 1 octave per min, 10 cycles per plan, 3 plans; din iec 68 t2 - 6 3. change of temperature: -55 c to 125c / 30 min. each / 10 cycles din iec 68 part 2 ? 14 test n 4. resistance to solder heat (reflow): reflow possible: twice max.; for temperature conditions refer to the attac hed "air reflow temperature conditions" on page 4; this filter is rohs compliant (2002/95/eg, 2005/618/eg) packing tape & reel: iec 286 ? 3, with exeption of value for n and minimum bending radius; tape type ii, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: 1700 reel of empty components at start: min. 300 mm reel of empty components at start including leader: min. 500 mm trailer: min. 300 mm g do w ct f e g d1 p2 p1 po bo ao pull off direction pin marker typ date code ko t a c n w 1 w 2 the minimum bending radius is 45 mm. tape (all dimensions in mm) w : 24,00 +0,30/-0,10 po : 4,00 0,1 do : 1,50 +0,1/0 e : 1,75 0,10 f : 11,50 0,10 g(min) : 0,60 p2 : 2,00 0,1 p1 : 12,00 0,1 d1(min) : 1,50 a o : 7,10 0,10 bo : 13,90 0,10 ct : 21,5 0,1 reel (all dimensions in mm) a : 330 w1 : 24,4 +2/-0 w2(max) : 30,4 n(min) : 60 c : 13,0 +0,5/-0,2
filename: tfs 80g.doc version 1.3 14.11.2005 vi telefilter filter specification tfs 80g 4/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. air reflow temperature conditions conditions exposure average ramp-up rate (30c to 217c) less than 3c/second > 100c between 300 and 600 seconds > 150c between 240 and 500 seconds > 217c between 30 and 150 seconds peak temperature max. 260c time within 5c of actual peak temperature between 10 and 30 seconds cool-down rate (peak to 50c) less than 6c/second time from 30c to peak temperature no greater than 300 seconds temperature / c time / s max. 260c 217c 10 ... 30 s 30 ... 150 s max. 300 s chip-mount air reflow profile
filename: tfs 80g.doc version 1.3 14.11.2005 vi telefilter filter specification tfs 80g 5/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. history version reason of changes name date 1.0 generation of development s pecification strehl 30.05.2005 1.1 change test circuit from 50 ? single ended to 100 ? differential environment strehl 01.07.2005 1.2 generation of filter specification; added typical values; added filter characteristic martens 02.11.2005 1.3 change stability characteristics, reliability strehl 14.11.2005
|
